Info

此问题已关闭。 请重新打开它进行编辑或回答。

How to change a block parameter using SimState?

1 次查看（过去 30 天）
Daniel Silva
Daniel Silva 2017-4-5
关闭： Sabin 2024-12-23
Hello everybody.
I'm trying to simulate different types of faults in a Simulink electrical power system. Then, I'm using SimState to get the system steady-state and from this point I want to apply the faults and check the behavior.
Thus, I'm using the Three-Phase Fault block to apply the fault and I need to change the type of fault at this block after SimState is loaded but system consider that is an error. How can I fix it?

此问题已关闭。

回答（0 个）

此问题已关闭。

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by