How to change a block parameter using SimState?

2 次查看（过去 30 天）
Daniel Silva
Daniel Silva 2017-4-5
Hello everybody.
I'm trying to simulate different types of faults in a Simulink electrical power system. Then, I'm using SimState to get the system steady-state and from this point I want to apply the faults and check the behavior.
Thus, I'm using the Three-Phase Fault block to apply the fault and I need to change the type of fault at this block after SimState is loaded but system consider that is an error. How can I fix it?

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Electromechanical 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by