configuration between picozed and host Computer

2017 4 24
1 个回答
更新时间：2017 5 16
3 次查看（30 天）

0 个投票

I want to work with matlab application using picozed hardware.now i used latest version(R2017a) trial pack.then i installed support package for Communication System Toolbox Support package for Xilinx Zynq based Radio Hardware .while setup the support package ping radio board failed in the final step.how to change the ip adress of the Picozed board.

请先登录，再回答此问题。

回答（1 个）

Noam Levine
Noam Levine 2017-5-16

0 个投票

You should be able to log onto the board via a terminal emulation program and set the IP address with the ifconfig command. See the Getting Started Guide for serial-port communications setup.
However, it may be more of a question of you Ethernet setup.
  • Are you connecting directly to the board via an Ethernet cable, or are you using a USB-to-Ethernet converter
  • Are there any IP address conflicts between different network adaptors?
  • Did you allow the setup process to program the SDCard for the hardware?

类别

在 帮助中心 和 File Exchange 中查找有关 Neuroimaging 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by