How do I debug Matlab NCO HDL Optimized in loop error?

1 次查看（过去 30 天）
Lee Thomas
Lee Thomas 2017-4-27
回答： Bharath Venkataraman 2017-4-27
I have a simulink file set up as follows:
With a simple state transistion chart:
with the NCO settings as follows:
When I attempt to compile the model, I get the following error:
"Dimensions of the input port 1 are unknown for MATLAB System block "myfile/NCO HDL Optimized1". This can happen when the input port is in a loop, is driven by a Ground block or a source with unspecified dimensions, or if the input port has unconnected signal lines. Consider adding a Signal Specification block with specified dimensions in front of the input port."
I've tried fiddling with the inc port data type converter but have been unable to get rid of the error and searching doesn't seem to bring up much information. However it will work if I remove the state chart.
What debugging steps should I take?
Can anyone explain this error?
What does the question mark denote on the simulink diagram?

请先登录，再回答此问题。

采纳的回答

Bharath Venkataraman
The NCO block is unable to determine the data types of its inputs. Please put in a Signal Specification block in front of the increment input and specify the datatype, size ([1 1] is scalar) and complexity.

更多回答（1 个）

Kiran Kintali
Kiran Kintali 2017-4-27
Can you please try making the chart "Moore" machine?
Thanks
  1 个评论
Lee Thomas
Lee Thomas 2017-4-27
Thanks, I get an error saying that state actions are not allowed in Moore charts (e.g. "entry")

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Signal Generation 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by