Ethernet connexion issue with FIL programmation
显示 更早的评论
Hi!
I'm working on an Altera Stratix IV board with a EP4SGX530KH40C2 device. At the end of the FPGA validation in filWizard with an Ethernet connection, I can see the Rx led lighting up but the Tx led stay not lighting and the ping is failed. I have to notice that the quartus programmer is still opened to keep the Ethernet connection available. Is there someone who already had this issue ?
Thanks for your help.
采纳的回答
Tao Jia
2017-6-2
0 个投票
Can you manually ping the board? If that works, you can probably ignore the auto validation error. You should be able to run FPGA-in-the-Loop feature normally by just waiting for the programmer to finish before starting the simulation.
更多回答（1 个）
Tao Jia
2017-6-1
0 个投票
I assume that you are using the SGMII mode to connect. In that case, the answer to this question might be helpful:
https://www.mathworks.com/matlabcentral/answers/337646-filwizard-error-during-validation-of-altera-stratix-iv-gx-230-fpga-development-kit
Basically, you'll need to make sure that the quartus programming is opened and running. Also, what is the PHY chip that you are using? There might be some compatibility issue.
类别
在 帮助中心 和 File Exchange 中查找有关 FPGA, ASIC, and SoC Development 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
