remove error message in command window

24 次查看（过去 30 天）
Yuli Hartini
Yuli Hartini 2017-5-11
评论： Image Analyst 2017-5-12
How to remove error message in command window matlab if we don't want the message to appear?
Is this possible?
note: I'm using m-file
Thanks before..
  1 个评论
Stephen23
Stephen23 2017-5-11
编辑：Stephen23 2017-5-11
Once the error message has been displayed in the command window there is not much that can be done about it, other than clearing the whole command window using clc. It might be easier to prevent it getting displayed in the first place: see the documentation for catch.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Jan
Jan 2017-5-11
error message are very important. Because they should never be ignored, it is a bad idea to remove them. A much better idea is to either avoid them, by considering the reasons, or to handle them in a TRY/CATCH block.
  2 个评论
Yuli Hartini
Yuli Hartini 2017-5-12
I just want to remove for one script on m-file program..
Because the program already succes to run..
But for some condition, the error message was appear.
Image Analyst
Image Analyst 2017-5-12
Are you sure it wasn't a warning (orange type instead of red)? Otherwise your program would not have finished (unless the error-causing code was in a try block).

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Programming 的更多信息

标签

产品


Translated by