i am trying to tune PID in my permanent magnet synchronous motor. there has 3 PID controller which is to control speed and direct and quadrature current. any best technique to tune this PID?

Question

Muhammad Syarqawi 2017-5-28

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/342230-i-am-trying-to-tune-pid-in-my-permanent-magnet-synchronous-motor-there-has-3-pid-controller-which-i

编辑： Arkadiy Turevskiy 2018-9-13

here is my permanent magnet synchronous motor model.i have problem in tune PID controller in my model where one to control speed and another two to control direct and quadrature current.any best technique to tune all 3 PID?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Arkadiy Turevskiy 2018-8-16

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/342230-i-am-trying-to-tune-pid-in-my-permanent-magnet-synchronous-motor-there-has-3-pid-controller-which-i#answer_333017

Please take a look at the this video and follow the approach shown.

2 个评论
显示无隐藏无

Al Ku 2018-9-11

编辑：Al Ku 2018-9-11

Hi, your approach needs Matlab 2018a, is there any approach without closed loop PID-Autotuner? (I´m using Matlab 2016b)

Arkadiy Turevskiy 2018-9-11

编辑：Arkadiy Turevskiy 2018-9-13

Hi Al,

The other approach is the following:

1. Do frequency response estimation - inject ac sweeps on d and q voltage and estimate frequency response from vd and vq to id, iq, and motor speed. See here on how to do frequency response estimation.

2. Once frequency response data is available, use system identification and identify a state space model from vd,vq to id,iq,speed

3. Once this state-space model is available, tune all 3 loops together using Control System Tuner .

Please check out this new 18b example showing this workflow.

请先登录，再进行评论。