Sending a 2MHz Baseband Signal using USRP and Simulink Block?

2 次查看（过去 30 天）
Matt Curtis
Matt Curtis 2017-6-6
回答： Arnav Mendiratta 2017-6-13
What are the maximum frequency restraints for transmitting a complex sine wave using the SDRu TX/RX blocks in Simulink for USRP? I am trying to send a 2MHz sine wave but is distorted on the RX side. I am setting my sampling rate in the sin wave block and TX/RX blocks to uphold the Nyquist sampling theorem. I am using the USRP N210 and WBX-40 daughtercard.

请先登录，再回答此问题。

回答（1 个）

Arnav Mendiratta
Arnav Mendiratta 2017-6-13
These blocks should be able to support frequencies in GHz range. Without your model, it's hard to figure out what the issue might be. Make sure you take care of your design as mentioned in the following discussion:
https://www.mathworks.com/matlabcentral/answers/227160-simulink-ettus-usrp-sdru-transmistter-receiver-blocks#comment_369986
If you are still facing issue, contact the engineers at MathWorks Technical Support .

类别

在 Help Center 和 File Exchange 中查找有关 Communications Toolbox 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by