Why does running Simulink in rapid acceleration mode cause a compiler error indicating that the line is too long?

17 次查看（过去 30 天）
MathWorks Support Team
编辑： MathWorks Support Team 2021-9-2
I have a model that I would like to run in rapid acceleration mode. However, when I attempt to run it, I get a compiler error, culminating in the following lines:
model_name.c:134 compiler limit: line too long (more than 20197 chars)
gmake: *** [model_name.obj] Error 1
I tried moving the files to a shorter directory, but that had no effect. What is causing this issue?

请先登录，再回答此问题。

采纳的回答

MathWorks Support Team
编辑：MathWorks Support Team 2021-9-2
This error may occur if the you do not have any installed/configured compilers (as may be verified by the output of the command "mex -setup"), in which case MATLAB defaults to lcc. 
The issue can be corrected by installing a supported compiler. Supported compilers are listed in the documentation at the following link:
https://www.mathworks.com/support/requirements/supported-compilers.html
 

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 MATLAB Support for MinGW-w64 C/C++ Compiler 的更多信息

标签

产品


版本

R2016b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by