how to use Slider Switch in simulink model ?

Question

jingwie sun 2017-6-22

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/345770-how-to-use-slider-switch-in-simulink-model

评论： Swarooph 2017-6-23

采纳的回答： Swarooph

How to use Slider Switch in simulink model ? Help document write a little bit.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Swarooph 2017-6-22

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/345770-how-to-use-slider-switch-in-simulink-model#answer_271605

This block enables you to control block parameters in the model. I've made a GIF below that shows how to work with this block. (Right click on image and open in a new window or tab to enlarge it):

Also take a look at the video at the link below for a general overview on Dashboard blocks:

Dashboard Block Library - Intro

In case you were not looking at the correct documentation link, you can find that as well below:

Slider Switch Documentation

2 个评论
显示无隐藏无

jingwie sun 2017-6-23

Why CANNOT link with constant block in my model? There are any limitation during use Dasboard

Swarooph 2017-6-23

在 MATLAB Online 中打开

Looks like you need to turn off the 'Inline Parameters' option from the configuration parameters. You can issue the following command at the command prompt. Note that mdlName is just a place holder and should be the actual name of the model.

set_param(mdlName,'DefaultParameterBehavior','Tunable')

After doing this, try what you have posted above.

请先登录，再进行评论。