Simscape gas pipe element causes initialization errors
显示 更早的评论
I have a Simscape model with a long thin (an inner diameter of 0.030") tube in the middle. When the tube is shorter (less than about 10 inches in length) the simulation runs perfectly, but when I change the tube to become longer (about 20 inches in length) I receive the following error message:
"Transient initialization, solving for consistent states and modes, failed to converge. Nonlinear solver: failed to converge, residual norm too large."
The actual tube is very long (multiple feet), so I don't know how to accurately model this in Simscape without getting error messages.
采纳的回答
Ankitha Kollegal Arjun
2017-7-25
0 个投票
It could be a modeling issue. Please use the troubleshooting steps mentioned in the following documentation to figure out any discrepancies in the model:
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Gas Models 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
