Simscape gas pipe element causes initialization errors

3 次查看(过去 30 天)
I have a Simscape model with a long thin (an inner diameter of 0.030") tube in the middle. When the tube is shorter (less than about 10 inches in length) the simulation runs perfectly, but when I change the tube to become longer (about 20 inches in length) I receive the following error message:
"Transient initialization, solving for consistent states and modes, failed to converge. Nonlinear solver: failed to converge, residual norm too large."
The actual tube is very long (multiple feet), so I don't know how to accurately model this in Simscape without getting error messages.

采纳的回答

Ankitha Kollegal Arjun
It could be a modeling issue. Please use the troubleshooting steps mentioned in the following documentation to figure out any discrepancies in the model:

更多回答(0 个)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by