How to implement partial band noise jamming in matlab?

5 次查看（过去 30 天）
Mubasher
Mubasher 2012-4-10
回答： Mahsa Hassankashi 2021-8-25
I am intended to implement communications schemes in the presence of jammming. So how can i implement jaming in matlab?
[Merged information from duplicate question]
i am doing a project in simulation and evaluation of different digtal modulation shemes in the presence of jamming. so i need to know how can i implement partial band noise jamming in awgn channel.

请先登录，再回答此问题。

回答（1 个）

Mahsa Hassankashi
Mahsa Hassankashi 2021-8-25
I think it is too late, but I hope it helps someone who refer to this question later.
As you use Bit Error Analysis Tool.
You need the proper coefficient for Eb/No which is defined as the normalized signal-to-noise ratio. For an instance, there are solutions for QASK, QPSK Modulations as follows:
I found the answer from the below article:
Coherent Detection of Frequency-Hopped Quadrature Modulations in the Presence of Jamming-Part I: QPSK and QASK Modulations, the authors are MARVIN K. SIMON, FELLOW, IEEE, AND ANDREAS POLYDOROS , and article is from IEEE TRANSACTIONS ON COMMUNICATIONS, VOL. COM-29, NO. 11, NOVEMBER 1981.

类别

在 Help Center 和 File Exchange 中查找有关 PHY Components 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by