Simulink Realtime: Define Target Using Script-Line Not sltrtexplr

3 次查看（过去 30 天）
Rashid
Rashid 2017-8-12
编辑： Brian Hannan 2017-8-12
In xPC Target, one could define a target with the command
target = xpc('TcpIp',address,port);
As of release 2017a, it seems this has been removed and the
slrt('TargetName')
command is required instead. While this works fine, it requires setting up the target parameters using the GUI interface with the slrtexplr command to be the same for every host and every target. For communication with a number of different target/host pairs, this means manually going through and making sure that the GUI-controlled target definition matches for each pair, which is somewhat cumbersome.
Is there some way to define a target through the script-line interface, like with the xpc command above, instead of using slrtexplr?

请先登录，再回答此问题。

采纳的回答

Brian Hannan
Brian Hannan 2017-8-12
编辑：Brian Hannan 2017-8-12
Use
tg = slrt;
tg.TcpIpTargetAddress = '10.10.10.10';
tg.TcpIpTargetPort = '22222';
etc.
See this doc page.

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Target Computer Setup 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by