Import data to splinetool create spline with function

3 次查看（过去 30 天）
Gavin Seddon
Gavin Seddon 2017-8-15
评论： Gavin Seddon 2017-8-23
Hello, initially I created a spline with cftool. Is it possible to import the same data to splinetool and generate the function? GS.
  1 个评论
Gavin Seddon
Gavin Seddon 2017-8-16
Hello, I should mention that I only want to provide evidence of a trigonometric spline so it is mainly importing data and if possible some evidence sine or cosine being used in the knot. GS.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Faiz Gouri
Faiz Gouri 2017-8-17
I understand that you have created a spline using 'cftool' and would like to use the same in 'splinetool'. You can do so by taking a function handle and use it in 'splinetool' An example follows: You can construct a cubic spline interpolant that matches the cosine function at the following sites x, using the csapi command.
x = 2*pi*[0 1 .1:.2:.9];
y = cos(x);
cs = csapi(x,y);
You can then view the interpolating spline by using fnplt and get its handle-
h = fnplt(cs,2);
Now, you can use 'h' in 'splinetool' when it prompts you to import your own data.
Hope this helps!
  3 个评论
显示 1更早的评论
Gavin Seddon
Gavin Seddon 2017-8-23
Is it possible to use all the x data from a table for input to this ? GS.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Splines 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by