How to use accelerometer block from simscape electronics?

Question

shreyas joshi 2017-9-14

1
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/356620-how-to-use-accelerometer-block-from-simscape-electronics

评论： Nicolas Schmit 2017-9-19

I am trying to use accelerometer block from simscape electronics block. i want to model the IMU sensing system in simulink. for that, i am using this block, But i am not able to understand what should be the input to this block.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Nicolas Schmit 2017-9-15

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/356620-how-to-use-accelerometer-block-from-simscape-electronics#answer_281625

The accelerometer bloc must be connected to an element from the mechanical translational domain (foundation library). The acceleration presented at the R port is mapped to an electrical signal.

If you want to use this bloc with Simscape multibody, you can interface the multibody domain with the mechanical translational domain, then connect the translational domain to the accelerometer. You can find examples on how to interface the multibody domain with the foundation domains in the Simscape Multibody Multiphysics Library.

2 个评论
显示无隐藏无

shreyas joshi 2017-9-15

Are there any simple examples available to interface accelerometer with multibody domain? I am connecting mechanical translational port directly to Accelerometer R input. since we get voltage output , if i connect display or scope at the output, it shows an error.

Nicolas Schmit 2017-9-19