How do I run a load flow analysis for a solar PV array?
显示 更早的评论
I simulated a microgrid on matlab simulink. I want to run a load flow analysis of the system. However matlab does not recognize the solar PV array in the microgrid as a source. When I place a load flow bus after the inverter of the PV array, it produces an error message saying the model does not converge. Increasing the number of iterations does not help. Any advice would be greatly appreciated
2 个评论
Mateus Franco
2019-1-22
Hello I have the same doubt, did you find the solution? Thanks for helping.
Rusith Grero
2019-1-23
回答（2 个）
Shafiq Aidil
2019-11-12
0 个投票
you can find it in simscape electrical library. just install add ons simscape and simscape electrial then you can find pv array in the library.
library>simscape>specelized power systems>renewable>solar
Joel Van Sickel
2020-9-2
0 个投票
Hello Rusith,
the inverter is not supported for load flow, here are the supported blocks:
Regards,
Joel
2 个评论
Youssef
2025-8-17
is the inverter become supported in the newer version?
youssef elsherif
best regards
Joel Van Sickel
2025-8-18
no, you will have to switch away from specialized power systems (simpowersystems) to Simscape (the blue blocks)
类别
在 帮助中心 和 File Exchange 中查找有关 Electrical Block Libraries 的更多信息
2017-9-25
2025-8-18
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
