How to reset a subsystem with trigger type "function call" in unit test?
显示 更早的评论
Hello everyone,
just I need to do an unit test for a subsystem with stateflow-charts. I have generated a test harness (test sequence) and tried to add some test cases.
However, I found I could not reset the subsystem. After running some test cases, the subsystem could not go back to initialization.
The subsystem has a trigger with following setting:
Trigger type: function-call; States when enabling: held; Propagate sizes of variable-size signals: During execution; Sample time type: triggered
This subsystem comes from a customer. Therefore, I hope that I don't need to change any thing in this subsystem.
A function-call scheduler was generated with send(trigger) automatically.
My question is:
how to reset the subsystem for each test case? I would like to know solutions for "test sequence" and "signal builder".
Thanks for your attention!
Best regards, XiC
1 个评论
Eeshan Mitra
2017-10-2
If the "function-call" subsystem is driven by the stateflow chart, have you tried wrapping it inside a resettable subsystem?
回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Schedule Model Components 的更多信息
2017-10-2
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
