set initial value for a signal and then rewrite it

Question

Peppe 2017-9-27

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/358646-set-initial-value-for-a-signal-and-then-rewrite-it

评论： Peppe 2017-10-10

Hi, I have a loop in which an observer observe the states and then backward it to a controller. There need to be an initial value for one signal. That signal will start the simulations and gets other values in the loop. Does anyone know how to set the initial value for such system in Simulink?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Jyotish Robin 2017-10-9

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/358646-set-initial-value-for-a-signal-and-then-rewrite-it#answer_284855

编辑：Jyotish Robin 2017-10-9

Hi!

As far as I understand you are looking for a way in which you can specify the initial value for a signal in a Simulink model.

Probably the IC block will fit your needs.

The IC block sets the initial condition of the signal at its input port, for example, the value of the signal at the simulation start time (t_start). The block does this by outputting the specified initial condition when you start the simulation, regardless of the actual value of the input signal. Thereafter, the block outputs the actual value of the input signal.

Hope this helps!

Regards,

Jyotish