清空筛选条件
清空筛选条件

sim command clears the workspace in a for loop

1 次查看（过去 30 天）
Mohammad
Mohammad 2017-9-30
编辑： Mohammad 2017-10-2
Hi I have a simulink model. There are two blocks in it which need to be updated. So I use "sim command" in a for loop in order to get data from previous step for the next one. But it seems that sim command clears the workspace in each iteration. So there is nothing in workspace. I tried
options = simset('SrcWorkspace','current', 'DstWorkspace', 'current');
but it wasn't helpful. I appreciate it if you could help me. Thanks. This is the code I use to run the model.
clc
clear all
T=100;
q=zeros(T,3);
m=zeros(T,2);
%M=tf([0.5],[1 1]);
%Q=tf([1 1],[2 1]);
for i=1:T
Q = tf([q(i,1) q(i,2)],[1 q(i,3)]);
M = tf([m(i,1)],[1 m(i,2)]);
options = simset('SrcWorkspace','current', 'DstWorkspace', 'current');
sim('adp_imc_1',[i i+1],options)
end
  3 个评论
显示 1更早的评论
Mohammad
Mohammad 2017-10-2
编辑：Mohammad 2017-10-2
@Omur Bas : Thanks for your comment but I think it's the sim command. because even when it's used out of the for loop for an interval like [1 2]and you want to do the simulation again without any "clear all command" the data related to the [1 2] is cleared. and we have the new data related to the new interval.
@ Stephen Cobeldick: I already used the piece of code mentioned in these posts. Nothing happened!

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Manual Performance Optimization 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by