Simulink PIL blocks.

2012 4 19
1 个回答
2 次查看（30 天）

0 个投票

I am using matlab R2011a , CCS v3.3 , c6713. I have kept a part of my simulink model inside one subsystem & converted it into a PIL block. Then I connected the PIL block inplace of the subsytem.. But when I run the model I am getting the following errors.
1) Error in 'notch/Subsystem2' while executing C MEX S-function 'Subsystem1_pbs', (mdlOutputs), at time 0.0.
2) An error occurred while calling into the SIL or PIL target connectivity implementation.
3) RunToHalt: Timed out waiting for CCS to confirm completion.
why am I getting these errors ???

请先登录，再回答此问题。

回答（1 个）

Kaustubha Govind
Kaustubha Govind 2012-4-19

0 个投票

Try increasing the "Maximum time allowed to complete IDE operation" on the IDE Link pane of the Configuration Parameters window?

4 个评论
显示 2更早的评论 隐藏 2更早的评论

Sujeet Kumar Padhi
Sujeet Kumar Padhi 2012-4-20
NO ma'am I am still not getting the result.
Now I am getting the following errors :
1) Error in 'notch/Subsystem2' while executing C MEX S-function 'Subsystem1_pbs', (mdlOutputs), at time 0.0.
2) An error occurred while calling into the SIL or PIL target connectivity implementation.
3) RunToHalt: Timed out waiting for CCS to confirm completion.
why am I getting these errors ???
4)Error in 'uwbtf/Subsystem' while executing C MEX S-function 'Subsystem_pbs', (mdlTerminate), at time 0.0.
5) An error occurred while calling into the SIL or PIL target connectivity implementation.
6) RunToHalt: Timed out waiting for CCS to confirm completion.
Kaustubha Govind
Kaustubha Govind 2012-4-20
How much did you increase the timeout by? Also, have you configured the target to use DSP/BIOS as OS? If yes, also try with "None" as OS.
Sujeet Kumar Padhi
Sujeet Kumar Padhi 2012-4-21
I increased the time to 20,50,100,200. I was not using any OS . I have tried with DSP/BIOS but after the building of the project when I connected the PIL & run the model...Time starts from T = 0.00 & it goes on increasing but I am not getting any output.(It didnt show any error this time).
I was getting errors when I didnt use any OS. But when I changed the timeout, now its not giving any errors but I am nt getting any result evenif the model runs for a long time... ???
Kaustubha Govind
Kaustubha Govind 2012-4-24
Hmm.. I don't know what you can do to get this working at this point. Please try contacting MathWorks Tech Support if you have a license that is on maintenance?

请先登录，再进行评论。

类别

在 帮助中心 和 File Exchange 中查找有关 Subsystems 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by