Simulink PIL blocks.

2 次查看（过去 30 天）

Sujeet Kumar Padhi 2012-4-19

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/35943-simulink-pil-blocks

I am using matlab R2011a , CCS v3.3 , c6713. I have kept a part of my simulink model inside one subsystem & converted it into a PIL block. Then I connected the PIL block inplace of the subsytem.. But when I run the model I am getting the following errors.

 1) Error in 'notch/Subsystem2' while executing C MEX S-function 'Subsystem1_pbs', (mdlOutputs), at time 0.0.
 2) An error occurred while calling into the SIL or PIL target connectivity implementation.
 3) RunToHalt: Timed out waiting for CCS to confirm completion.

why am I getting these errors ???

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Kaustubha Govind 2012-4-19

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/35943-simulink-pil-blocks#answer_45060

Try increasing the "Maximum time allowed to complete IDE operation" on the IDE Link pane of the Configuration Parameters window?

4 个评论
显示 2更早的评论隐藏 2更早的评论

Sujeet Kumar Padhi 2012-4-21

I increased the time to 20,50,100,200. I was not using any OS . I have tried with DSP/BIOS but after the building of the project when I connected the PIL & run the model...Time starts from T = 0.00 & it goes on increasing but I am not getting any output.(It didnt show any error this time).

I was getting errors when I didnt use any OS. But when I changed the timeout, now its not giving any errors but I am nt getting any result evenif the model runs for a long time... ???

Kaustubha Govind 2012-4-24

Hmm.. I don't know what you can do to get this working at this point. Please try contacting MathWorks Tech Support if you have a license that is on maintenance?

请先登录，再进行评论。

请先登录，再回答此问题。