shouldn't the reference frame replace the frames of the subsystem

1 次查看（过去 30 天）
NASADUDE
NASADUDE 2017-10-10
回答： Qu Cao 2017-10-17
Hi I am building a robot arm simulation
and I built every joint out of cylinders then made it a subsystem.
the frames is not where they should be so I am added a reference frame to the subsystem
but when I Specify Position in the State Targets in the Z Reveloute Primitive (Rz) it still use one the 2 solids' frames and this is what I end up getting.
bold where its obviously rotating around the axis shown in the picture (above) which is one of the solids' Axis (solid 9) and not the reference frame . can someone tell me what am I doing wrong??? Thank you very much

请先登录，再回答此问题。

回答（1 个）

Qu Cao
Qu Cao 2017-10-17
Since the Reference Frame is attached to Solid 8 not the World Coordinate, the rotating axis will be one of the Solids 8's references frame.

类别

在 Help Center 和 File Exchange 中查找有关 Robotics 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by