I want to cycle the signal simulink according to my application i can't use any repeat blocks.How can i do it ?

2 次查看（过去 30 天）
Harini pushparaj
Harini pushparaj 2017-10-30
评论： Harini pushparaj 2017-10-30
Hi...I have a specific length of signal.I don't know the length of the signal .I should repeat the signal.If youu see in the file I have already created a single cycle but sending the speed and time data in the look up table and got the single cycle .I want to repeat the cycle.

请先登录，再回答此问题。

采纳的回答

Fangjun Jiang
Fangjun Jiang 2017-10-30
编辑：Fangjun Jiang 2017-10-30
It is somewhat difficult to repeat a user defined signal input in Simulink. In your case though, I can think of a solution.
Since you have the single cycle data in the 1-D lookup table, your must know the time duration of your single cycle signal. Let's say the data is from time 0 to time 8.4 seconds, you can add an "Interpreted MATLAB Function" block between the Clock and the lookup table block. The function you need to specify is mod(u,8.4), you will then get an endless repeat of your single cycle signal.
  6 个评论
显示 4更早的评论
Harini pushparaj
Harini pushparaj 2017-10-30
In the code you have mention the length of the vector as 80 know .Here the problem is I should also calculate the length of the vector because the single generated is according to the data collected in time.So I should measure the length of the signal ,see where it ends and reset it again to zero and repeat the same.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Signal Generation 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by