Obfuscation and traceability information generation cannot both be enabled at the same time.
1 次查看(过去 30 天)
显示 更早的评论
Hi,
I am new to Matlab Simulink and I am working on Lego3. I am using Lego EV3 Libraries and I created a very simple program(attached here). But when I try to download the program, it throws the following error: Obfuscation and traceability information generation cannot both be enabled at the same time. Disable Obfuscation or disable both the 'Code-to-model' and the 'Model-to-code' navigation options on the Configuration Parameters > All Parameters tab.
How can I remove this error?
Regards Vishav
3 个评论
Amy Olivier
2018-8-21
I have the same problem and can't find the solution, I really hope mathworks will help
CRISTINA RAMOS
2021-1-6
I was having the same problem but the I wrote the following in the command window after all the setup and it worked:
r = raspberrypi
回答(1 个)
ES
2018-8-21
Do you really need the traceability info? If not, you may do as suggested in the warning.
"Disable Obfuscation or disable both the 'Code-to-model' and the 'Model-to-code' navigation options on the Configuration Parameters > All Parameters tab."
1 个评论
Amy Olivier
2018-8-21
I tried to do that, but I can't find the Obfuscation or the Code-to-model and model-to-code in the all parameters tab
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 MATLAB Support Package for LEGO MINDSTORMS EV3 Hardware 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!