Error while loading interface model of QPSK HW/SW AD9361 example interface model
显示 更早的评论
In the factory configuration, toolchain cannot be set to "Xilinx Software Development Kit (SDK)" when 'Hardware board' is set to "Xilinx Zynq Based Radio Board Target". In the model configuration properties, above settings are present by default and I have not changed any of the configuration parameters. This error keeps occurring frequently. But on re-run, sometimes the model runs on the PICOZED hardware without any errors. How to resolve this issue?
回答（1 个）
Emmanouil Tzorakoleftherakis
2018-1-8
0 个投票
Hi Vinay,
I am assuming you are referring to this example. Try following the steps under the "Setup" section in the link, i.e., reinstall the two support packages and run the configuration steps again to make sure everything is set up properly. If this does not resolve the issue, can you reply with the exact error that you are getting?
类别
在 帮助中心 和 File Exchange 中查找有关 RF Blockset Models for Transceivers 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
