Insert Custom Code into Built Code (Simulink Embedded Coder)
7 次查看(过去 30 天)
显示 更早的评论
I have created an application for a TI F28035 microcontroller in Simulink using the TI C2000 hardware add-on. Everything works just fine. However, I was wondering if there was a way to insert custom lines of c code into the auto-generated code. I'm not talking about S functions or ceval calls or using the custom code portion of the Model Parameters. I'm talking about a simple block that lets you enter some simple lines of c code that when built will just plop those lines of code into the built code. Does anything like that exist?
0 个评论
回答(2 个)
Fangjun Jiang
2018-1-30
In your version of Simulink, check Simulink Coder, Custom Code, Model Source block. It allows to add source code at either Top or Bottom of the model source code.
3 个评论
Fangjun Jiang
2018-1-30
In that case, use a Stateflow chart inside a triggered subsystem. You can pretty much write any manual code inside the Stateflow chart.
Mark McBroom
2018-3-10
Only way I know of is to create in-lined s-function. For Simulation, s-function would have no inputs, no outputs and therefore do nothing. For code generation, the TLC code for the s-function could emit the above code.
0 个评论
另请参阅
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!