Simulink COM port error

Nicholas Imlay

2018 2 5

3 个回答

16 次查看（30 天）

2 个投票

If I do not connect to Arduino Due with MatLab. I get the following response in the diagnostic viewer.

The following error occurred during deployment to your hardware board: Could not connect to specified Arduino board.

Verify that the board is connected to your host, and that the host COM port number set in the model matches the COM port number in Windows.

To change the host COM port number in the model, click 'Simulation ', click 'Model Configuration Parameters'... In the dialog that opens, select the 'Hardware Implementation' pane, click 'Target hardware resources > Host-board connection' and set the COM port number.

To find out the COM port number in Windows, open Device Manager and open your board in the COM ports group.

My COM port for the arduino is COM3, which I have already set manually in Simulink.

If I connect to the arduino from MatLab, I get the following response.

The following error occurred during deployment to your hardware board: Open failed: Port: COM3 is not available. No ports are available. Use INSTRFIND to determine if other instrument objects are connected to the requested device.

3 个评论
显示 1更早的评论隐藏 1更早的评论

HITESH TRIVEDI 2019-3-20

I too tried it , it doesn't work....can anyone help us??

Zaryan 2024-3-15

i have ch340g arduino mega and i am facing same issue

请先登录，再进行评论。

请先登录，再回答此问题。

Follow Question

回答（3 个）

Kevin Graebner 2019-4-22

1 个投票

I am running matlab r2019A and am having the same issue, though i just recently updated the arduino packs.

the funny thing is when i follow the arduino engineering tutorial it works ok but when i just try to get a digital input signal to show up on a scope it wont work at all! please help

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

menezes roshal nikhil 2019-7-4

Same problem here, before update everything workes fine

请先登录，再进行评论。

Mirko Milz 2020-4-15

1 个投票

Hi guys, i had the same problem. Try to press and hold the ERASE Button on Due Board for about 3 seconds before you start the simulation (Create and run instrumented application on hardware. Monitor signals and tune parameters (external mode)). You have to do this before each new simulation.

Hope this helps you.