Wireless filtered signal data transfer using zigbee

2018 2 10
1 个回答
更新时间：2018 2 11
133 次查看（30 天）

0 个投票

Hi I have to send my filtered signal through zigbee .is xctu must for that?? If not please share basic code to read signal input from matlab by zigbee and my reciever side ardiuno connected with reciever zigbee and led where led gets input from zigbee.please help me I am new to this.I have filtered signal output in script editor as m file.

2 个评论
显示 无 隐藏 无

Walter Roberson
Walter Roberson 2018-2-10
xctu appears to be used to configure the zigbee but not to transmit the data. Are you trying to do the zigbee configuration without using xctu at all?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

0 个投票

I have tried with xctu.but I got error message as failed to program since I am using405f firmware ZigBee.There is no coordinator api for this ZigBee in xctu as I am using 405f ZigBee in transmitter and receiver as well.So I tried up to my knowledge in xctu.Can you tell about zigbee configuration in MATLAB itself along with transmission code rather than usi ng xctu or else clear me with the error message appears on xctu while configuring.

类别

在 帮助中心 和 File Exchange 中查找有关 MATLAB 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by