清空筛选条件
清空筛选条件

J1939 Communication over CAN -Vehicle Network Toolbox

2 次查看（过去 30 天）
ilker ozturk
ilker ozturk 2018-2-14
编辑： ilker ozturk 2018-3-16
Dear Users and Matlab team,
I am trying to read can singnals of bms function using vehicle network toolbox. I have a dbc file which describes can signals of bms. But when I open the dbc file using J1939 Configration blok, Matlab said that Network Configration might not be valid J1939 File. But I am sure that dbc file was produced under J1939 standarts. Do you know any way to test dbc file for checking standarts, using Matlab? Could you help me about this issue?
Best Regards

请先登录，再回答此问题。

采纳的回答

ilker ozturk
ilker ozturk 2018-3-16
编辑：ilker ozturk 2018-3-16
Dear All,
Solution is basic, add DbBusName,BusType and ProtocolType to the Attributes section in your dbc file, Matlab accepts this solution with J1939 Communication Blocks.
Best Regards

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Vehicle Network Toolbox 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by