Open loop transfer function this circuit

2018 2 18
1 个回答
回答已采纳
更新时间：2018 2 20
4 次查看（30 天）

0 个投票

Hello, Could you please help me get the Modeling of this circuit I'm so weak at modeling and i want to Try Pid on it afterward.

4 个评论
显示 2更早的评论 隐藏 2更早的评论

M
M 2018-2-19
What kind of model are you using ? What are your inputs ? outputs ?
Zack El
Zack El 2018-2-19
My input is the Variable resistor and the output is the motor when i change the value of the resistor the motor speed changes.
M
M 2018-2-19
And what is the relationship between these two variables ? To simulate (and control) your system, you should be able to represent it with an equation.
Zack El
Zack El 2018-2-19
That is what I need the equation. So let's assume that the output is V and it's equal to the volt in the fixed resistor so the output is the Fixed resistor.

请先登录，再进行评论。

请先登录，再回答此问题。

 采纳的回答

Birdman
Birdman 2018-2-20

0 个投票

I prepared a model. What I basically did is modelling the voltage divider part of yours with a MATLAB Function(please see the content of it in model) and DC motor part with Transfer Fcn blocks. I set the both resistors to be changeable during the simulation(gave them as inputs to the function) and by a slider parameter, you can also change the weight of the variable resistor during simulation and instantly see the results on Scope. Change this model according to your needs and I believe it will be easy to implement PID on it afterwards. Note that I set the simulation time to Inf so that you can easily observe what happens to the speed of the motor when you change the resistor's value by its parameter.
Hope this helps.

更多回答（0 个）

类别

在 帮助中心 和 File Exchange 中查找有关 Motor Drives 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by