Rerun Simulink without compiling

11 次查看（过去 30 天）
matquest
matquest 2018-3-12
评论： matquest 2018-3-12
I have some code which uses Simulink and I've noticed that Simulink re-compiles every time I run the code. It takes almost 5 minutes for it to compile which adds quite a bit of overhead, especially if I'm just trying to debug matlab code.
I'm guessing that there's some setting to enable/disable the compilation, but unfortunately I haven't been able to find it. How can I disable the automatic compilation and just manually compile it when I need to?

请先登录，再回答此问题。

回答（1 个）

Sara Nadeau
Sara Nadeau 2018-3-12
Hi matquest,
You can enable fast restart using the FastRestart model parameter .
  1 个评论
matquest
matquest 2018-3-12
Thanks; I'll try it and see how it works. Does it only allow a fast-restart during a single matlab session or can it accept compiled code from a previous session? (e.g., I open matlab, compile and run, close matlab, and then reopen and run the code)

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by