Arduino Internal Pull Up Mode in Simulink

14 次查看（过去 30 天）
Cou
Cou 2018-3-24
评论： Hans Scharler 2018-4-8
Is there a way to set the pin mode to pull up in Simulink? I see there is a method in MATLAB:
a = arduino('COM4','Uno');
configurePin(a,'D3','pullup');
How would I set this for my Simulink model? Thanks!
  2 个评论
Hans Scharler
Hans Scharler 2018-3-27
编辑：Hans Scharler 2018-3-27
I will find someone to help you with this. What are you building?
Cou
Cou 2018-3-27
Hi Hans, Thanks. I am using the Sparkfun CAN BUS shield. The joystick requires pullups. Prior to configuring pins for pull up, you would configure them in Arduino IDE as
pinMode(A1,INPUT);
digitalWrite(A1, HIGH);
This is not an option since you cannot read and write to the same pin at the same time in Simulink.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Cou
Cou 2018-4-8
I created a custom device driver to solve my problem. The block can be found here: Arduino Pinmode Input Pull Up

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by