MiniZed Support Package for Simulink and Matlab 2018a - how to setup SDK?
5 次查看(过去 30 天)
显示 更早的评论
Hello,
I installed the Linux sytem for the Matlab/Simuling HW/SW codesign on my Minized.
I went through the installation and setup procedure provided my minized.org, but I cannot figure out how to setup the SDK to work with Matlab/Simulink.
I tried to follow the procedure to configure the Embedded Coder Support Package for Xilinx Zynq Platform by selecting Add-Ons > Manage Add-Ons, but things have changed in the 2018a version.
I cannot figure out how to point to my SDK.
THe setup defaults to the c: drive, but my SDK is setup for the d: drive.
Any ideas on how to fix that?
Thanks,
Arne
0 个评论
回答(2 个)
Noam Levine
2018-4-12
Arne - Did you see the new MiniZed support package from Avnet in the Add-On Explorer? They define a MATLAB set-up process, including the need to run a minized_setup.m after the support package is installed.
0 个评论
Arne
2018-5-18
1 个评论
frank wu
2020-5-31
Hi Arne, You have to use Matlab R2017a/b. See http://www.zedboard.org/content/minized-and-matlab-20181-file-missing.
另请参阅
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!