How can I fix propagation speed error using Simscape Power System?

58 次查看（过去 30 天）
Euan McLean
Euan McLean 2018-3-30
评论： Steve Miller 2022-4-11
I’m running 2017b, using a model I think was created in 2015x. When I try to run the model, I receive the following error:
“A propagation speed of...has been found for Mode 1 Block 10. Propagation speed must be < 300000 km/s.”
Analysis of the model forms part of a university coursework, and I can’t see anything obvious to change to allow it to run correctly. Thanks.
  3 个评论
显示 1更早的评论
kalim ullah
kalim ullah 2021-3-5
I am facing the same problem, and not even able to adjust it by adjusting LC parameters of PI line. What I should do? please suggest

请先登录，再进行评论。

请先登录，再回答此问题。

回答（2 个）

Tarun Sangwan
Tarun Sangwan 2022-4-9
propogation time=distance/propagation speed(commonly reffered to speed of light)
if there is propagation error you must check value for positive and negative sequence inductance.
try making it greater than 1
Prasanth Sunkara
Prasanth Sunkara 2018-4-2
Hello Euan,
It seems to be an "improper" configuration of the Simscape TL blocks.
The error message you see from the model is due to propagation speeds larger than 300000 km/s, which is causing the propagation time to be smaller than the sample time. Please refer to the following links to understand more about the parameters and block equations for Distributed Parameter Line and PI Section Line:
http://www.mathworks.com/help/physmod/sps/powersys/ref/distributedparameterline.html
http://www.mathworks.com/help/physmod/sps/powersys/ref/pisectionline.html
- Prasanth

类别

在 Help Center 和 File Exchange 中查找有关 Nonlinear Operators 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by