Save Video on XPC Target

1 次查看（过去 30 天）
Nicholas
Nicholas 2012-5-23
回答： Pika 2018-9-21
I am getting a video stream from my xpc target machine via USB webcam, but I would like to be able to save the video file to the internal Hard Drive of my target machine. Does anyone know how to go about doing this?

请先登录，再回答此问题。

回答（2 个）

Kaustubha Govind
Kaustubha Govind 2012-5-23
Not a 100% sure that this is the right solution, but how about connecting the output of the webcam driver to a xPC File Scope block?
  12 个评论
显示 10更早的评论
Nicholas
Nicholas 2012-6-8
Thanks for your help. I've contacted technical support for assistance.
Aram Simonian
Aram Simonian 2012-10-29
Hi, I have exactly the same problem. The only difference is that I use a CameraLink camera. What did the MathWorks support suggest to you? Thanks for any advice.

请先登录，再进行评论。

Pika
Pika 2018-9-21
Can you give me some explanation about how to read usb camera? I have set up a target, which works well without reading usb camera. After add the usb video device module to the model, the following problems exist: (1) This usb video device module can not detect the camera connected to the target. If I connect this camera to the development computer, it works well with the vision machine toolbox. (2) This application can be loaded to the target, but I cannot start it and a error message "Video device is not found" is displayed.

类别

在 Help Center 和 File Exchange 中查找有关 Computer Vision with Simulink 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by