PZMAP IS NOT ACCURATE
7 次查看(过去 30 天)
显示 更早的评论
Dear all
I found a bug of matlab. when I use the matlab function "pzmap" to draw the poles and zeros, these poles should be located on the unit circle, however, in the matlab, they are located outside of the unit circle. Please have a look at the code below: the poles should be:p1=exp(-jwg*Ts), p2=exp(jwg*Ts). However, when we use "pzmap" to draw it, it is outside of the unit circle. Does anyone know how to solve it?
%%the matlab function is as follows: %% Ts=1e-4; wg=2*pi*50; z=tf('z'); Gc=(z^2-1)/(z^2-2*z*cos(wg*Ts)+1); pzmap(Gc); %%
0 个评论
回答(2 个)
Birdman
2018-4-5
Do not be bothered by that. You know that the magnitude of the pole should give you 1:
0.9995^2+0.0314^2=1
The reason it stands outside has something to do with your sampling time. If you check the Bode plot of the system, you will see that even sampling with 10kHz is not enough since the magnitude at that frequency is still high comparing to low frequencies. Therefore choose your sampling time as high as possible. The poles will stand closer to the unit circle, but will not be exactly on the unit circle. For instance increase the sampling time to 1e-8 and observe the Bode plot again.
bode(Gc)
Hope this helps.
8 个评论
Birdman
2018-4-5
But conversion fron continuous to discrete always contains this kind of tradeoffs. Therefore my suggestion is to make analysis via Bode plots.
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Stability Analysis 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!