Using simulink SimState with different look up table data

4 次查看（过去 30 天）
Thijs van Krimpen
回答： Thijs van Krimpen 2018-5-11
So my problem is that i have a simulink model with a slow start up and afterwards decent run time. I'd like to use the restart (load initial state) functionality. However when i change a lookup table I get the error that the model has changed and simulink cannot use the initial state.
The lookup table contains the data i wish to change for each loadcase. with zero values for the first 15 seconds, and im trying to restart after 10 second so the data should be the same.
Is there a workaround for this issue?
Or to rephrase, how to load simulation specific parameters into simulink whilst still being able to load an initial sim state?

请先登录，再回答此问题。

采纳的回答

Thijs van Krimpen
Thijs van Krimpen 2018-5-11
Eventually i found that loading data from a file rather than the workspace does not trigger the model change check.

更多回答（1 个）

Mark McBroom
Mark McBroom 2018-4-7
Try using fast restart. This option disables some consistency checks performed during model initialization and may let you get around this problem. Obviously the burden is on you to ensure that the changed lookup table values don't influence the saved simstate.

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Environment Customization 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by