Phase and Gain alignment
3 次查看(过去 30 天)
显示 更早的评论
Hi all
I have simultaneously recorded data coming from three pre-amplifiers with same input applied to these pre-amps. After post analysis, i found that there are phase and gain differences among these outputs ( which should be zero in ideal case). I set one preamplifer output as reference and measure the phase and gain difference values of other two preamps with respect to this reference using "fft technique" for a typical frequency value.
Now question is how can i use these phase/gain difference values to align all three signals in software?
Note: Idea is to save these phase/gain coefficients permanently and multiply them with each corresponding preamplifier's outputs (excluding reference ) sample by sample for each acquisition so that inherent phase/gain difference b/w preamplifiers can be adjusted without modifying the electronics.
Thanks
0 个评论
回答(0 个)
另请参阅
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!