Phase and Gain alignment

4 次查看（过去 30 天）
nauman
nauman 2018-4-8
Hi all
I have simultaneously recorded data coming from three pre-amplifiers with same input applied to these pre-amps. After post analysis, i found that there are phase and gain differences among these outputs ( which should be zero in ideal case). I set one preamplifer output as reference and measure the phase and gain difference values of other two preamps with respect to this reference using "fft technique" for a typical frequency value.
Now question is how can i use these phase/gain difference values to align all three signals in software?
Note: Idea is to save these phase/gain coefficients permanently and multiply them with each corresponding preamplifier's outputs (excluding reference ) sample by sample for each acquisition so that inherent phase/gain difference b/w preamplifiers can be adjusted without modifying the electronics.
Thanks

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Transmitters and Receivers 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by