Updating the Active Power of a Three-Phase Parallel RLC Load during Simulation Run Time
5 次查看(过去 30 天)
显示 更早的评论
Hi all,
I have a simulink simulation that runs for 20s. At every 5s, it will perform a new set of calculations and update the variable 'R' in the workspace automatically via the 'assignin' command.
Now I would need to read in this updated variable into the Active Power (under block parameters) of the Three-Phase Parallel RLC Load in my simulink model. May I know if the set_param command is able to perform this function in this situation? Or is it impossible to write into the Active Power of the Three-Phase Parallel RLC Load?
Any help or advice would be greatly appreciated! Thank you!
Best Regards, Rachel
This
Best Regards, Rachel
0 个评论
回答(1 个)
Sabin
2023-10-3
Probably best to use variable Resistor/inductor/capacitor in this situation. It is then possible to update the value during simulation.
Variable resistor in Simscape technology:
Variable resistor in Specialized Power Systems technology:
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Switches and Breakers 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!