Is it possible continue a simulation from one point intermediate?

Question

Tony Castillo 2018-5-2

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/398655-is-it-possible-continue-a-simulation-from-one-point-intermediate

回答： lokender Rawat 2018-5-8

Hello dear Ms,I want to ask you the following question, is it possible continue a simulation from one point intermediate?. Let me explain my issue, in my case my PC turned off when my simulation was running near to 60 %, but my prior intention was finish it, it is supposed that I need it get the end at 100 %, is there a way to re-runn continue that the simulation in order to complete it?. I mean, I'd like to re-run for completing the 40 % that left. My motivation to do the above menctioned, is because my simulation takes more than one week to be done. It lasts too much time for finish the experiments. Do anyone knows how to do it in simulink simpowersystem? Sincerely,

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Tony Castillo 2018-5-7

This seems be the answer: https://es.mathworks.com/help/simulink/ug/saving-and-restoring-the-simulation-state-as-the-simstate.html

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

lokender Rawat 2018-5-8

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/398655-is-it-possible-continue-a-simulation-from-one-point-intermediate#answer_319200

Yes, you can refer the below link to find how to go about that:

Saving & Restoring Simulation

But kindly read the "Restore SimState" and "Limitations of SimState" section of the document link carefully. You will have to figure it out on your end as what parameters/initial conditions/final output values etc. you want to store in 'simstate' variable. You can then load these variables and start the next simulation cycle as desired.