清空筛选条件
清空筛选条件

session based daq interface+usb-6218 shows drift

1 次查看（过去 30 天）
Richard
Richard 2012-5-30
i'm using matlab 2011b together with the daq toolbox (session-based interface) and a NI 6218 usb-daq to acquire data from a six axis load cell.
all channels seem to work properly according to measurement and automatation. also i have used the same setup and code successfully with a pci-6225.
the measurement shows a strange drift (without applying any load) when measuring (compare figure: http://imageshack.us/photo/my-images/196/problemsdaq.jpg/). though they react on applied load. is there anything i need to change or some other known issues with the usb-6218?
thank you,
richard

请先登录，再回答此问题。

回答（2 个）

Walter Roberson
Walter Roberson 2012-5-30
There was a question some months ago about drift when using the legacy interface; http://www.mathworks.com/matlabcentral/answers/24758-drift-in-data-acquisition-toolbox-legacy-interface
There was also a question about drift when using multiple clocks in a session-based interface: http://www.mathworks.com/matlabcentral/answers/24757-daq-session-based-input-is-it-possible-to-have-different-clocks-for-input-and-output
Tobias
Tobias 2012-8-13
Hi,
should the device work in single ended mode or in the differential mode? You need to determine that in your code. This could cause drifts.
Best Regards Tobi

类别

在 Help Center 和 File Exchange 中查找有关 Simultaneous and Synchronized Operations 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by