清空筛选条件
清空筛选条件

While Saving the figure in pdf format (MATLAB 2010A)it shows an error message saying PSlevel must be 1 or 2. What should i do to have my figure in pdf? And after clicking on Exit debug mode it shows the file with the error on line 206/1063..

5 次查看（过去 30 天）
MANMATH PANIGRAHY
回答： Sujay Kadam 2022-5-26
  1 个评论
Vishwanath Bailore Acharya
Vishwanath Bailore Acharya 2018-5-21
Can you once try saving the figure using 'hgexport' with just 2 parameters, by removing the style format as follows?
hgexport(hfig, filename);
Please update if you are facing the issue after trying the above command.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Sujay Kadam
Sujay Kadam 2022-5-26
May be this is too late, but I wonder if the following would help:
clear fig_property
fig_property.PSLevel= '1';
hgexport(gcf,'Plot.pdf',fig_property);

类别

在 Help Center 和 File Exchange 中查找有关 Migrate GUIDE Apps 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by