While Saving the figure in pdf format (MATLAB 2010A)it shows an error message saying PSlevel must be 1 or 2. What should i do to have my figure in pdf? And after clicking on Exit debug mode it shows the file with the error on line 206/1063..
4 次查看(过去 30 天)
显示 更早的评论
1 个评论
Vishwanath Bailore Acharya
2018-5-21
Can you once try saving the figure using 'hgexport' with just 2 parameters, by removing the style format as follows?
hgexport(hfig, filename);
Please update if you are facing the issue after trying the above command.
回答(1 个)
Sujay Kadam
2022-5-26
May be this is too late, but I wonder if the following would help:
clear fig_property
fig_property.PSLevel= '1';
hgexport(gcf,'Plot.pdf',fig_property);
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Interactive Control and Callbacks 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!