bwlabel changing connectivity of image

7 次查看（过去 30 天）

Ryan 2012-5-31

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/40008-bwlabel-changing-connectivity-of-image

I am trying to use BWLabel to label 1 pixel width line segments. These lines are not straight so I am using a connectivity of 8. When I run bwlabel and view the image of the newly labeled skeleton, it actually is changing layout, size and connectivity of the line segments. The input image is a double. I am using Matlab R2009b.

Before BWLabel: http://i.imgur.com/t3Q1C.jpg

After BWLabel: http://i.imgur.com/Sju5B.jpg

Am I asking bwlabel to be too sensitive? I am using this as part of a larger code that is trying to find the angle of these segments by using the segment endpoints, so maintaining separation is important.

Below is the code I used to generate the two supplied images

% A = image to be labeled.
figure(1), imshow(A)
A2 = bwlabel(A,8);
figure(2), imshow(A2)

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Image Analyst 2012-5-31

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/40008-bwlabel-changing-connectivity-of-image#answer_49626

在 MATLAB Online 中打开

Your A image is not what you think it is. I'd bet that it is not a logical image, but a gray scale image with most pixels at 255 but some pixels at a much darker value. Do this

imhist(A);

and see what it shows. Do you have only 2 bins at 0 and 1? Or do you have bins at 0, 255, and, say, 20 or some small number?

You can also try this

A = (A == 255); % Convert to logical image with 1 only where A = 255.

and then label and see what you get.

5 个评论
显示 3更早的评论隐藏 3更早的评论

Ryan 2012-6-1

I also utilize 'help ....' all the time.

Ryan 2012-6-1

You were correct. I ran the 'unique' function that Stephen suggested and got [-1 0 1], so I just ran the im2bw command with a high threshold value and it solved the issue.

请先登录，再进行评论。

更多回答（1 个）

Stephen 2012-5-31

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/40008-bwlabel-changing-connectivity-of-image#answer_49641

I agree with Image Analyst. Is your image a jpg or has it been compressed? If so, there are little ghosts that lurk as low intensity values on certain pixels. bwlabel uses any value above 0 (or below?) so those sneaky pixels will get marked. Take a look at what a==0 looks like, or type unique(a) to see a list of the unique intensity values.