I want to send a matrix to arduino by matlab but i m unable to open the serial port. using command 'instrfind' i get the status of com3 as close. so fopen() command doesnt execute it gives an error message (Open failed: Port: COM3 ). what to do now?

Question

Bushra Ali 2018-5-10

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/400130-i-want-to-send-a-matrix-to-arduino-by-matlab-but-i-m-unable-to-open-the-serial-port-using-command

评论： Madhu Govindarajan 2018-5-10

I want to send a matrix to arduino by matlab but i m unable to open the serial port. using command 'instrfind' i get the status of com3 as close. so fopen() command doesnt execute it gives an error message

Open failed: Port: COM3 is not available. No ports are available. Use INSTRFIND to determine if other instrument objects are connected to the requested device

By instrfind command i am getting Instrument Object Array

   Index:    Type:     Status:   Name:  
   1         serial    open      Serial-COM3
   2         serial    closed    Serial-COM3
 what to do now?

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

Bushra Ali 2018-5-10

在 MATLAB Online 中打开

after clearing the workspace I run the instrfind command again and get these results. Can someone plz specify where I am going wrong.

instrfind

   Serial Port Object : Serial-COM3
   Communication Settings 
      Port:               COM3
      BaudRate:           9600
      Terminator:         'LF'
   Communication State 
      Status:             closed
      RecordStatus:       off
   Read/Write State  
      TransferStatus:     idle
      BytesAvailable:     0
      ValuesReceived:     0
      ValuesSent:         0

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Madhu Govindarajan 2018-5-10

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/400130-i-want-to-send-a-matrix-to-arduino-by-matlab-but-i-m-unable-to-open-the-serial-port-using-command#answer_319630

在 MATLAB Online 中打开

Clearing the workspace is not sufficient to delete existing connections. Try

>> delete(instrfindall)

This should delete existing connections. Then you should be able to create a new connection by typing

>> s1 = serial('COM7') 
>> fopen(s1)

Madhu

PS - Accept the answer if this works. I feel like this will be a frequent flyer and would be great to establish an answer that works for everyone.

4 个评论
显示 2更早的评论隐藏 2更早的评论

Walter Roberson 2018-5-10

See https://docs.microsoft.com/en-ca/sysinternals/downloads/portmon for one serial port monitor for Windows.

Madhu Govindarajan 2018-5-10

Here are my thoughts - MATLAB and Serial monitor are fighting for the same resource. So maybe if you close the connection once you are done sending, then hypothetically you should be able to open Serial monitor after that. But all of this is manual and might not work for you, best would be to test it manually and then use the digital pin like you are doing to test if you received the data.

HTH, Madhu

请先登录，再进行评论。