fmincon and exitflag = -2 or 2 / non respect of constrained conditions
21 次查看(过去 30 天)
显示 更早的评论
Hello everyone,
I'm creating a model on Matlab for optimization with inequality constraints, especially the minimization of a function with several variables (at least 4). I'm trying to run the optimization for many times to get a list of solutions, gotten by a parameter varying at each simulation.
However, I cannot solve problems I met: - exitflag = -2 most of the time and 2 for the other simulations. I don't know where I can correct or change to get exitflag = 1. - among constrained conditions I set, some of them aren't respected after minimizations.
If someone could advice me what method I could follow?
Thank you for the answer.
General description of the model: *------ objective : minimize a section ( I shape) submitted to a tension force *------ variables : thicknesses, height, wide *------- constraints : - section > 0 - variables >0 + linear inequality relation between two of them - tension stress < certain value in MPa : non respected condition
0 个评论
采纳的回答
Sargondjani
2012-6-1
编辑:John Kelly
2015-3-2
getting exit message 2 is not bad but if you insist on having 1, you could try to use smaller values for TolX (ie.. 1e-10 or even 1e-14)
as for exit message -2: there could be many causes.
if you choose a feasible starting point, fmincon should be able to find a solution i guess...
but maybe you could also post the output of the last couple of iterations and the exit message? and the fmincon command + options? otherwise it is very hard to guess what's going on
更多回答(2 个)
Alan Weiss
2012-6-6
编辑:John Kelly
2015-3-2
If you have a Global Optimization Toolbox license, you could try MultiStart. If you like, you can filter the initial points so the local solver uses only feasible starting points, although I am not sure this is really necessary. See this link for general information about how to use MultiStart, and this link to see the effect of using only feasible start points.
Good luck,
Alan Weiss
MATLAB mathematical toolbox documentation
4 个评论
Sargondjani
2012-6-8
you have three input variables so you could make a 3D grid and solve for all points in the grid.
you could start with a wide grid with not so many points and then make a finer grid around the points that give feasible solutions, or something like that
Ahmed Rageh
2018-7-4
Where could I find TolX? the code has TolFun and TolCon only.
options = optimset('Display','iter','TolFun',1e-10,'TolCon',1e-10)
1 个评论
Walter Roberson
2018-7-6
TolX is still the name to use with optimset() .
If you were updating to the newer option routines, you would use StepTolerance, or XTolerance for GlobalSearch and MultiStart
另请参阅
产品
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!