How to apply Vdc and Vdc reference to PI controller?

5 次查看（过去 30 天）
SUTAPA DEB
SUTAPA DEB 2018-5-18
回答： Sabin 2023-2-11
In the model I have attached herewith of "Grid Converter Implementation in a wind turbine based on Doubly Fed Induction Generator" if I want to get output on correspondence with voltage across capacitance between two bridge rectifier which is Vdc, how can i implement these in the controller of grid side? I just tried myself as i marked in the controller(Right hand side of main diagram,Untitled1.jpg and grid side controller,Untitled2.jpg).I tried to work on the basis of following link
https://www.youtube.com/watch?v=0uLjcCORlzA&t=1669s

请先登录，再回答此问题。

回答（1 个）

Sabin
Sabin 2023-2-11
The measured DC-link voltage, Vdc, is connected to both Vdc and Vdc_reference. This is not correct. Ther reference is the setpoint you want to track while Vdc is the measured value. The controller is then trying to follow the reference.

类别

在 Help Center 和 File Exchange 中查找有关 Simscape Electrical 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by