Angle between a vector and the positive X axis

2012 6 4
4 个回答
更新时间：2020 8 14
28 次查看（30 天）

0 个投票

Hi all,
I wish to find the angle between a vector that has the equation y=m*x+c and the positive X axis. Is there a way in MATLAB that I can do it. I get the values for m and c using polyfit. The slope m doesnt always give the angle with reference to the positive X axis. I was wondering if there is an easier way in MATLAB to do this.
Your help is appreciated.

请先登录，再回答此问题。

回答（4 个）

Steve Eddins
Steve Eddins 2012-6-4

0 个投票

Try this:
atan(m)
If you need the answer in degrees, then:
atan(m) * 180 / pi

1 个评论
显示 -1更早的评论 隐藏 -1更早的评论

Neena
Neena 2012-6-4
编辑：Walter Roberson 2020-8-14
Hi Steve,
The reason why I want to know this is that I want to rotate the vector by the angle so that its direction is along the positive X axis. I use atan(m) for the analysis. But sometimes it gives me errorenous results. Take for instance this example. (I have given my code as well)
X=[0 -0.1705 -0.1630 -0.0060 -0.0308];
Y=[0 -1.0382 -2.2907 -3.2725 -3.6321];
x1=[X;Y];
poly=polyfit(x1(1,1:4),x1(2,1:4),1); %the vector is the line that fits the first four points
theta=atan(poly(1));
%this is the way I find the correct angle of rotation.
sumx=sum(x1(1,:));
if (sumx>0)
theta=-theta;
else
theta=-(pi+theta);
end
%computation of rotation angle
rot=[cos(theta) -sin(theta); sin(theta) cos(theta)];
x2=rot*x1;
plot(x1(1,:),x1(2,:))
hold on
plot(x2(1,:),x2(2,:),'*r')
even though the vector points along the negative X direction, atan gives an angle estimate of about 20 degrees. Can you please tell me what I am doing wrong. I want x1 to point along the positive X axis after rotation.

请先登录，再进行评论。

oblivious
oblivious 2012-6-4

0 个投票

you might want to consider all possible combinations i.e. 1st and 2nd quadrant.
b=atan(m);
if b<0
ang=pi+b;
else ang=b;
end
Ryan seader
Ryan seader 2020-8-14

0 个投票

You decide to find a resultant of more than just two forces by resolving each individual force into its rectangular components and then combining them to find the rectangular components of the resultant force. You do not want to use the triangle rule with the law of sines and cosines, because you would need to do it first for the first two vectors and then again to combine the third vector with the resultant of the first two. The following steps can be arranged to allow for the determination of the magnitude and direction of the resultant force of multiple forces using their rectangular components. Give the correct order in which to implement each step, assuming that you are going to calculate the magnitude of the resultant first before you calculate its direction.

类别

在 帮助中心 和 File Exchange 中查找有关 Axis Labels 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by